3Com S7902E Command Reference Manual - page 1827
1-11
Parameters
None
Description
Use the
dot1x multicast-trigger
command to enable the multicast trigger function of 802.1X to send
multicast trigger messages to the clients periodically.
Use the
undo dot1x multicast-trigger
command to disable this function.
By default, the multicast trigger function is enabled.
Related commands:
display dot1x
.
Examples
# Disable the multicast trigger function for interface GigabitEthernet2/0/1.
[Sysname] interface GigabitEthernet2/0/1
[Sysname- GigabitEthernet2/0/1] undo dot1x multicast-trigger
dot1x port-control
Syntax
In system view:
dot1x
port-control
{
authorized-force
|
auto
|
unauthorized-force
}
[
interface interface-list
]
undo dot1x
port-control
[
interface interface-list
]
In Ethernet interface view:
dot1x
port-control
{
authorized-force
|
auto
|
unauthorized-force
}
undo dot1x
port-control
View
System view, Ethernet interface view
Default Level
2: System level
Parameters
authorized-force
: Places the specified or all ports in the authorized state, allowing users of the ports to
access the network without authentication.
auto
: Places the specified or all ports in the unauthorized state initially to allow only EAPOL frames to
pass, and turns the ports into the authorized state to allow access to the network after the users pass
authentication. This is the most common choice.
unauthorized-force
: Places the specified or all ports in the unauthorized state, denying any access
requests from users of the ports.
interface interface-list
: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list
argument is in the format of
interface-list
= {
interface-type
interface-number
[
to
interface-type
interface-number
] } & , where
interface-type
represents the port type,
interface-number
represents the port number, and & means that you can provide up to 10 port