3Com S7902E Command Reference Manual - page 2283
1-6
[Sysname] ntp-service access peer 2001
ntp-service authentication enable
Syntax
ntp-service authentication enable
undo ntp-service authentication enable
View
System view
Default Level
2: System level
Parameters
None
Description
Use the
ntp-service authentication enable
command to enable NTP authentication.
Use the
undo ntp-service authentication enable
command to disable NTP authentication.
By default, NTP authentication is disabled.
Examples
# Enable NTP authentication.
[Sysname] ntp-service authentication enable
ntp-service authentication-keyid
Syntax
ntp-service authentication-keyid
keyid authentication-mode
md5
value
undo ntp-service authentication-keyid
keyid
View
System view
Default Level
2: System level
Parameters
keyid
: Authentication key ID, in the range of 1 to 4294967295.
authentication-mode
md5 value
: Specifies to use the MD5 algorithm for key authentication, where
value
represents authentication key and is a string of 1 to 32 characters.
Description
Use the
ntp-service authentication-keyid
command to set the NTP authentication key.