3Com S7902E Command Reference Manual - page 1208
1-51
[Sysname] pim
[Sysname-pim] state-refresh-interval 70
state-refresh-rate-limit (PIM view)
Syntax
state-refresh-rate-limit interval
undo state-refresh-rate-limit
View
Public instance PIM view, VPN instance PIM view
Default Level
2: System level
Parameters
interval
: Time to wait before receiving a new refresh message, in seconds and with an effective range of
1 to 65535.
Description
Use the
state-refresh-rate-limit
command to configure the time the router must wait before receiving a
new state refresh message.
Use the
undo state-refresh-rate-limit
command to restore the system default.
By default, the device waits 30 seconds before receiving a new state refresh message.
Related commands:
pim state-refresh-capable
,
state-refresh-interval
,
state-refresh-ttl
.
Examples
# In the public instance configure the device to wait 45 seconds before receiving a new state refresh
message.
[Sysname] pim
[Sysname-pim] state-refresh-rate-limit 45
state-refresh-ttl
Syntax
state-refresh-ttl ttl-value
undo state-refresh-ttl
View
Public instance PIM view, VPN instance PIM view
Default Level
2: System level