3Com S7902E Command Reference Manual - page 1413
1-42
Default Level
1: Monitor level
Parameters
interface-type interface-number
: Specifies to reset the IPv6 PIM control message counter on a
particular interface. If no interface is specified, this command will clear the statistics information about
IPv6 PIM control messages on all interfaces.
Description
Use the
reset pim ipv6 control-message counters
command to reset IPv6 PIM control message
counters.
Examples
# Reset IPv6 PIM control message counters on all interfaces.
source-lifetime (IPv6 PIM view)
Syntax
source-lifetime
interval
undo source-lifetime
View
IPv6 PIM view
Default Level
2: System level
Parameters
interval
: IPv6 multicast source lifetime in seconds, with an effective range of 1 to 65,535.
Description
Use the
source-lifetime
command to configure the IPv6 multicast source lifetime.
Use the
undo source-lifetime
command to restore the system default.
By default, the lifetime of an IPv6 multicast source is 210 seconds.
Examples
# Set the IPv6 multicast source lifetime to 200 seconds.
[Sysname] pim ipv6
[Sysname-pim6] source-lifetime 200
source-policy (IPv6 PIM view)
Syntax
source-policy
acl6-number