3Com S7902E Command Reference Manual - page 1763
1-22
Parameters
disable
: Disables the idle cut function.
enable minute
: Enables the idle cut function. The
minute
argument refers to the allowed idle duration, in
the range 1 to 120 minutes.
Description
Use the
idle-cut
command to enable or disable the idle cut function.
By default, the function is disabled.
Related commands:
domain
.
Examples
# Enable the idle cut function and set the idle threshold to 50 minutes for ISP domain
aabbcc.net
.
[Sysname] domain aabbcc.net
[Sysname-isp-aabbcc.net] idle-cut enable 50
level
Syntax
level level
undo level
View
Local user view
Default Level
3: Manage level
Parameters
level
: Level of the user, which can be 0 for visit level, 1 for monitor level, 2 for system level, and 3 for
manage level. A smaller number means a lower level.
Description
Use the
level
command to set the level of a user.
Use the
undo level
command to restore the default.
By default, the user level is 0.
Note that:
z
If you specify not to perform authentication or use password authentication, the level of the
commands that a user can use after logging in depends on the level of the user interface. For
details about the authentication, refer to command
authentication-mode
in
User Interface
Commands
of the
System Volume.
z
If you specify an authentication method that requires the username and password, the level of the
commands that a user can use after logging in depends on the level of the user. For an SSH user
using RSA public key authentication, the commands that can be used depend on the level
configured on the user interface.