3Com S7902E Command Reference Manual - page 2210
1-7
Default Level
1: Monitor level
Parameters
interface-type interface-number
: Specifies an interface by its type and number.
Description
Use the
display poe interface power
command to display the power information of a PoE
interface(s).
If no interface is specified, the power information of all PoE interfaces will be displayed.
Examples
# Display the power information of Ethernet 2/0/1.
Interface CurPower PeakPower MaxPower PD Description
(W) (W) (W)
Eth2/0/1 15.0 15.3 15.4 Acess Point on Room 509 for Peter
# Display the power information of all PoE interfaces.
Interface CurPower PeakPower MaxPower PD Description
(W) (W) (W)
GE2/0/25 4.4 4.5 4.6 IP Phone on Room 309 for Peter Smith
GE2/0/26 4.4 4.5 15.4 IP Phone on Room 409 for Peter Pan
GE2/0/27 15.0 15.3 15.4 Acess Point on Room 509 for Peter
GE2/0/28 0 0 0 IP Phone on Room 609 for Peter John
GE2/0/29 0 0 0 IP Phone on Room 709 for Jack
GE2/0/30 0 0 0 IP Phone on Room 809 for Alien
--- 3 port(s) on, 23.8(W) consumed, 776.2(W) Remaining ---
Table 1-4
display poe interface power command output description
Field
Description
Interface
Shortened form of a PoE interface
CurPower
Current power of a PoE interface
PeakPower
Peak power of a PoE interface
MaxPower
Maximum power of a PoE interface
PD Description
Description of the PD connected with a PoE interface When
the description contains more than 34 characters, the first 30
characters followed by four dots are displayed.
port(s) on
Number of PoE interfaces that are supplying power
consumed
Power currently consumed by all PoE interfaces
Remaining
Total remaining power of the system