3Com S7902E Command Reference Manual - page 2249
1-4
destination port
Syntax
destination
port port-number
undo
destination
port
View
TCP, UDP-echo, UDP-jitter test type view
Default Level
2: System level
Parameters
port-number
: Destination port number of a test operation, in the range 1 to 65535.
Description
Use the
destination port
command to configure a destination port number for a test operation.
Use the
undo destination port
command to remove the configured destination port number.
By default, no destination port number is configured for a test operation.
Note that you are not recommended to perform a UDP-jitter test on ports from 1 to 1023 (known ports).
Otherwise, the NQA test will fail or the corresponding services of this port will be unavailable.
Examples
# Configure the destination port number of a test operation as 9000.
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-echo
[Sysname-nqa-admin-test-udp-echo] destination port 9000
display nqa
Syntax
display
nqa
{
result
|
history
} [
admin-name
operation-tag
]
View
Any view
Default Level
2: System level
Parameters
result
: Displays the results of the last test.
history
: Displays the history records of a test.
admin-name
: Specifies the name of the administrator who creates NQA operations, a string of 1 to 32
characters. It is case-insensitive.