3Com S7902E Command Reference Manual - page 794
1-62
View
OSPF area view
Default Level
2: System level
Parameters
no-summary
: Usable only on a stub ABR. With it configured, the ABR advertises only a default route in
a Summary LSA into the stub area (such a stub area is known as a totally stub area).
Description
Use the
stub
command to configure an area as a stub area.
Use the
undo stub
command to remove the configuration.
No area is stub area by default.
Note that, to concel the
no-summary
configuration on the ABR, simply execute the
stub
command
again to overwrite it.
To configure an area as a stub area, all routers attached to it must be configured with this command.
Related commands:
default-cost
.
Examples
# Configure Area1 as a stub area.
[Sysname] ospf 100
[Sysname-ospf-100] area 1
[Sysname-ospf-100-area-0.0.0.1] stub
stub-router
Syntax
stub-router
undo stub-router
View
OSPF view
Default Level
2: System level
Parameters
None
Description
Use the
stub-router
command to configure the router as a stub router.
Use the
undo
stub-router
command to restore the default.
By default, no router is configured as a stub router.