3Com S7902E Command Reference Manual - page 242
1-1
1
GARP/GVRP Configuration Commands
GARP Configuration Commands
display garp statistics
Syntax
display
garp statistics
[
interface interface-list
]
View
Any view
Default Level
1: Monitor level
Parameters
interface
interface-list
: Defines one or multiple Ethernet ports for which the GARP statistics will be
displayed. You can provide up to 10 Ethernet port lists, by each of which you can specify an individual
port in the form of
interface-type interface-number
, or a port range in the form of
interface-type
interface-number1
to
interface-type interface-number2
, where the end-port number specified by
interface-number2
must be greater than the start-port number specified by
interface-number1
. If no
ports are specified, this command displays the GARP statistics for all ports.
Description
Use the
display
garp statistics
command to display the GARP statistics of the specified port(s) or all
ports if no ports are specified.
This command displays the statistics about GVRP packets received, transmitted, and dropped on
GVRP-enabled ports. When the system is restarted or after you perform the
reset garp statistics
command, the existing packet statistics are cleared and the system starts to collect new GARP statistics.
With the statistics, you can judge whether a GVRP-enabled port is operating normally.
z
If the number of received and transmitted GVRP packets on the port is the same as that on the
remote port, it indicates that the two ends are transmitting and receiving GVRP packets normally
and no registration information is lost.
z
If there are dropped GVRP packets on the port, check its registration mode. GVRP packets are
likely to be dropped if the registration mode is fixed or forbidden, because dynamic VLANs cannot
be registered in either of the modes.
Examples
# Display statistics about GARP for port GigabitEthernet 2/0/1.
GARP statistics on port GigabitEthernet2/0/1