3Com S7902E Command Reference Manual - page 540
2-5
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] dhcp relay information enable
[Sysname-Vlan-interface1] dhcp relay information strategy replace
[Sysname-Vlan-interface1] dhcp relay information format verbose
dhcp relay information remote-id format-type
Syntax
dhcp relay information remote-id format-type
{
ascii
|
hex
}
undo dhcp relay information remote-id format-type
View
Interface view
Default Level
2: System view
Parameters
ascii
: Specifies the code type for the remote ID sub-option as
ascii
.
hex
: Specifies the code type for the remote ID sub-option as
hex
.
Description
Use the
dhcp relay information remote-id format-type
command to configure the code type for the
non-user-defined remote ID sub-option.
Use the
undo dhcp relay information remote-id format-type
command to restore the default.
By default, the code type for the remote ID sub-option is HEX.
Note that:
This command applies to configuring the non-user-defined remote ID sub-option only. After you
configure the padding content for the remote ID sub-option using the
dhcp relay information
remote-id string
command, ASCII is adopted as the code type.
Examples
# Configure the code type for the non-user-defined remote ID sub-option as
ascii
.
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] dhcp relay information remote-id format-type ascii
dhcp relay information remote-id string
Syntax
dhcp relay information remote-id string
{
remote-id
|
sysname
}
undo dhcp relay information remote-id string
View
Interface view