3Com S7902E Command Reference Manual - page 101
1-18
The latest configuration takes effect if you configure the
value
argument for multiple times in Ethernet
interface view or port-group view.
Examples
# Enable jumbo frames to pass through all the Ethernet interfaces in the manual port group named
group1
.
[Sysname] port-group manual group1
[Sysname-port-group manual group1] group-member ethernet 2/0
[Sysname-port-group manual group1] jumboframe enable
# Enable jumbo frames to pass through Ethernet 2/0/1.
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] jumboframe enable
link-delay
Syntax
link-delay delay-time
undo link-delay
View
Ethernet interface view
Default Level
2: System level
Parameters
delay-time
: Up/down suppression time for the physical connection of the Ethernet interface (in seconds),
in the range 0 to 30.
Description
Use the
link-delay
command to configure the suppression time of physical-link-state changes on the
Ethernet Interface.
Use the
undo link-delay
command to restore the default suppression time.
By default, the suppression time is 0 second, that is, the physical layer will report physical-link-state
changes without delay.
Examples
# Set the up/down suppression time of the physical connection of interface Ethernet 2/0/1 to 8 seconds.