3Com S7902E Command Reference Manual - page 1809
3-12
Default Level
2: System level
Parameters
ip-address
: IP address of the server, a valid unicast address in dotted decimal notation. The default is
0.0.0.0.
port-number
: Port number of the server. It ranges from 1 to 65535 and defaults to 49.
Description
Use the
secondary accounting
command to specify the secondary HWTACACS accounting server.
Use the
undo secondary accounting
command to remove the configuration.
By default, no secondary HWTACACS accounting server is specified.
Note that:
z
The IP addresses of the primary and secondary accounting servers cannot be the same. Otherwise,
the configuration fails.
z
The HWTACACS service port configured on the device and that of the HWTACACS server must be
consistent.
z
If you configure the command for more than one time, the last configuration takes effect.
z
You can remove an accounting server only when no active TCP connection for sending accounting
packets is using it.
Examples
# Specify the secondary accounting server.
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] secondary accounting 10.163.155.12 49
secondary authentication (HWTACACS scheme view)
Syntax
secondary authentication
ip-address
[
port-number
]
undo secondary authentication
View
HWTACACS scheme view
Default Level
2: System level
Parameters
ip-address
: IP address of the server, a valid unicast address in dotted decimal notation. The default is
0.0.0.0.
port-number
: Port number of the server. It ranges from 1 to 65535 and defaults to 49.