3Com S7902E Command Reference Manual - page 2286
1-9
Description
Use the
ntp-service in-interface disable
command to disable an interface from receiving NTP
messages.
Use the
undo
ntp-service in-interface disable
command to restore the default.
By default, all interfaces are enabled to receive NTP messages.
Examples
# Disable VLAN-interface 1 from receiving NTP messages.
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service in-interface disable
ntp-service max-dynamic-sessions
Syntax
ntp-service max-dynamic-sessions number
undo ntp-service max-dynamic-sessions
View
System view
Default Level
2: System level
Parameters
number
: Maximum number of dynamic NTP sessions that are allowed to be established, in the range of
0 to 100.
Description
Use the
ntp-service max-dynamic-sessions
command to set the maximum number of dynamic NTP
sessions that are allowed to be established locally.
Use the
undo ntp-service max-dynamic-sessions
command to restore the maximum number of
dynamic NTP sessions to the system default.
By default, the number is 100.
Examples
# Set the maximum number of dynamic NTP sessions allowed to be established to 50.
[Sysname] ntp-service max-dynamic-sessions 50
ntp-service multicast-client
Syntax
ntp-service
multicast-client
[
ip-address
]
undo ntp-service multicast-client
[
ip-address
]