3Com S7902E Command Reference Manual - page 1071
1-1
1
Route Policy Configuration Commands
z
The term “router” in this document refers to a router in a generic sense or a Layer 3 switch.
z
The common configuration commands of route policy are applicable to both IPv4 and IPv6.
z
EA boards (such as LSQ1GP12EA and LSQ1TGX1EA) do not support IPv6 features.
Common Route Policy Configuration Commands
apply as-path
Syntax
apply as-path as-number
&
[
replace
]
undo apply as-path
View
Route policy view
Default Level
2: System level
Parameters
as-number
: Autonomous system number, in the range of 1 to 65535.
&
: Indicates you can enter up to 10 AS numbers.
replace
: Replaces the original AS numbers.
Description
Use the
apply as-path
command to apply the specified AS numbers to BGP routes.
Use the
undo apply as-path
command to remove the clause configuration.
No AS_PATH attribute is set by default.
With the
replace
keyword included, the
apply as-path
command replaces the original AS_PATH
attribute with the specified AS numbers. Without the
replace
keyword, this command adds the specified
AS numbers before the original AS_PATH attribute.
Examples
# Configure node 10 in permit mode of route policy
policy1
: add AS number 200 before the original
AS_PATH attribute of BGP routing information matching AS-PATH list 1.