3Com S7902E Command Reference Manual - Mbgp Configuration Commands
1-1
1
MBGP Configuration Commands
z
The term “router” in this document refers to a generic router or an Ethernet switch running routing
protocols.
z
For information about route policy commands, refer to
Route Policy Commands
in the
IP Routing
Volume
.
MBGP Configuration Commands
aggregate (MBGP family view)
Syntax
aggregate
ip-address
{
mask
|
mask-length
}
[
as-set
|
attribute-policy
route-policy-name
|
detail-suppressed
|
origin-policy
route-policy-name
|
suppress-policy
route-policy-name
] *
undo aggregate
ip-address
{
mask
|
mask-length
}
View
IPv4 MBGP address family view
Default Level
2: System level
Parameters
ip-address
: Summary address.
mask
: Summary mask, in dotted decimal notation.
mask-length
: Summary mask length, in the range 0 to 32.
as-set
: Creates a summary with AS set.
attribute-policy
route-policy-name:
Sets the attributes of the summary route according to the route
policy. The route policy name is a string of 1 to 19 characters.
detail-suppressed
: Advertises the summary route only.
suppress-policy route-policy-name
: Suppresses specific routes defined in the route policy. The route
policy name is a string of 1 to 19 characters.
origin-policy
route-policy-name
: References the route policy to determine routes for summarization.
The route policy name is a string of 1 to 19 characters.
The keywords of the command are described as follows: