3Com S7902E Command Reference Manual - page 850
1-51
SNMP Trap is enabled by default.
Examples
# Enable SNMP Trap.
[Sysname] isis
[Sysname-isis-1] is-snmp-traps enable
log-peer-change (IS-IS view)
Syntax
log-peer-change
undo log-peer-change
View
IS-IS view
Default Level
2: System level
Parameters
None
Description
Use the
log-peer-change
command to enable the logging of IS-IS neighbor state changes.
Use the
undo log-peer-change
command to disable the logging.
The logging is enabled by default.
After the logging is enabled, information about IS-IS adjacency state changes is sent to the
configuration terminal.
Examples
# Enable logging on the IS-IS adjacency state changes.
[Sysname] isis
[Sysname-isis-1] log-peer-change
lsp-fragments-extend
Syntax
lsp-fragments-extend
[ [
level-1
|
level-2
|
level-1-2
] | [
mode-1
|
mode-2
] ] *
undo lsp-fragments-extend
View
IS-IS view