3Com S7902E Command Reference Manual - page 129
1-9
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] enable snmp trap updown
interface bridge-aggregation
Syntax
interface bridge-aggregation interface-number
undo interface bridge-aggregation interface-number
View
System view
Default Level
2: System level
Parameters
interface-number
: Layer-2 aggregate interface number. The value range is 1 to 1,024..
Description
Use the
interface bridge-aggregation
command to create a Layer-2 aggregate interface and enter the
Layer-2 aggregate interface view.
Use the
undo
interface bridge-aggregation
command to remove a Layer-2 aggregate interface.
Upon creation of a Layer-2 aggregate interface, a Layer-2 aggregation group numbered the same is
created automatically. Removing the Layer-2 aggregate interface also removes the Layer-2
aggregation group. At the same time, the member ports of the aggregation group, if any, leave the
aggregation group.
Examples
# Create Layer-2 aggregate interface
Bridge-aggregation 1
.
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1]
lacp port-priority
Syntax
lacp
port-priority
port-priority
undo
lacp
port-priority
View
Ethernet interface view
Default Level
2: System level