3Com S7902E Command Reference Manual - page 151
1-9
View
System view
Default Level
2: System level
Parameters
enhance
: Specifies the enhanced DLDP mode. When a device operates in this mode and a neighbor
entry it maintains expires, the device detects the neighbor before removing the neighbor entry.
normal
: Specifies the normal DLDP mode. When a device operates in this mode and a neighbor entry it
maintains expires, the device removes the neighbor entry directly.
Description
Use the
dldp work-mode
command to set the DLDP mode.
Use the
undo dldp work-mode
command to restore the default DLDP mode.
By default, a device operates in normal DLDP mode.
Note that:
z
In normal DLDP mode, only fiber cross-connected unidirectional links can be detected.
z
In enhanced DLDP mode, two types of unidirectional links can be detected. One is fiber
cross-connected links. The other refers to fiber pairs with one fiber not connected or disconnected.
The support for these two commands varies with device models.
Examples
# Configure the device to operate in enhanced DLDP mode.
[Sysname] dldp work-mode enhance
reset dldp statistics
Syntax
reset dldp statistics
[
interface-type interface-number
]
View
User view
Default Level
1: Monitor level