3Com S7902E Command Reference Manual - page 2274
1-29
Default Level
2: System level
Parameters
None
Description
Use the
display nqa server status
command to display NQA server status.
Examples
# Display NQA server status.
nqa server is: enabled
tcp-connect:
IP Address Port Status
2.2.2.2 2000 active
udp-echo:
IP Address Port Status
3.3.3.3 3000 inactive
Table 1-3 display nqa server status
command output description
Field
Description
tcp-connect
NQA server status in the NQA TCP test
udp-echo
NQA server status in the NQA UDP test
IP Address
IP address specified for the TCP/UDP listening service on the NQA server
Port
Port number of the TCP/UDP listening service on the NQA server
Status
Listening service status:
active
: Listening service is ready;
inactive
: Listening service is not ready.
nqa server enable
Syntax
nqa server enable
undo nqa server enable
View
System view
Default Level
2: System level
Parameters
None