3Com S7902E Command Reference Manual - page 1595
1-12
Parameters
interface interface-type interface-number
: Specifies the interface connecting the CE by its type and
number.
remote-info
: Specifies Martini VCs from the remote peer.
Description
Use the
display mpls l2vc
command to display information about Martini VCs configured on the router.
If you specify an interface, the command displays information about Martini VCs configured on the CE
interface.
Examples
# Display information about all Martini VCs configured on the router.
total ldp vc : 3 0 up 3 down
Transport Client VC Local Remote Tunnel
VC ID Intf State VC Label VC Label Policy
5 Vlan2 down 0 0 lsp3
6 Vlan3 down 0 0 lsp2
7 Vlan4 down 0 0 plcy3
Table 1-9 display mpls l2vc
command output description
Field
Description
total ldp vc
Total number of Martini VCs
Transport VC ID
Remote VC ID
Client Intf
Interface connected with the CE
VC State
Status of the VC
Remote VC Label
Remote VC label
Tunnel Policy
Tunnel policy configured
# Display information about Martini VCs received from the remote peer.
total remote ldp vc : 1
Transport Group Peer Remote Remote C Remote
VC ID ID Addr Encap VC Label Bit MTU
100 0 3.3.3.9 ethernet 1025 0 1500
Table 1-10 display mpls l2vc remote-info
command output description
Field
Description
total remote ldp vc
Total number of remote LDP VCs
Transport VC ID
Remote VC ID
Group ID
Remote VC group ID, used for the L2VPN VC FEC TLV field of
LDP messages
Peer Addr
IP address of the peer