3Com S7902E Command Reference Manual - page 1224
1-12
Default Level
2: System level
Parameters
interface-type interface-number
: Specifies an interface by its type and number.
Description
Use the
originating-rp
command to configure the address of the specified interface as the RP address
of SA messages.
Use the
undo originating-rp
command to restore the system default.
Be default, the PIM RP address is used as the RP address of SA messages.
Examples
# Specify the IP address of VLAN-interface 100 as the RP address of SA messages.
[Sysname] msdp
[Sysname-msdp] originating-rp vlan-interface 100
peer connect-interface
Syntax
peer peer-address
connect-interface
interface-type interface-number
undo peer peer-address
View
Public instance MSDP view, VPN instance MSDP view
Default Level
2: System level
Parameters
peer-address
: MSDP peer address.
interface-type interface-number
: Specifies an interface by its type and number. The local device will use
the IP address of the specified interface as the source IP address when setting up a TCP connection
with the remote MSDP peer.
Description
Use the
peer connect-interface
command to create an MSDP peer connection.
Use the
undo
peer connect-interface
command to remove an MSDP peer connection.
No MSDP peer connection is created by default.
Be sure to carry out this command before you use any other
peer
command; otherwise the system will
prompt that the peer does not exist.
Related commands:
static-rpf-peer
.