3Com S7902E Command Reference Manual - page 434
1-23
mstp
: Configures an MSTP-enabled device to work in MSTP mode.
Description
Use the
stp mode
command to configure the MSTP work mode of the device.
Use the
undo stp mode
command to restore the MSTP work mode to the default setting.
By default, an MSTP-enabled device works in MSTP mode.
Related commands:
stp mcheck
,
stp
.
Examples
# Configure the MSTP-enabled device to work in STP-compatible mode.
[Sysname] stp mode stp
stp no-agreement-check
Syntax
stp no-agreement-check
undo stp no-agreement-check
View
Ethernet port view, port group view, Layer-2 aggregate port view
Default Level
2: System level
Parameters
None
Description
Use the
stp no-agreement-check
command to enable No Agreement Check on the port(s).
Use the
undo stp no-agreement-check
command to disable No Agreement Check on the port(s).
By default, No Agreement Check is disabled.
Note that:
z
Configured in port view, the setting takes effect on the current port only; configured in port group
view, the setting takes effect on all ports in the port group.
z
Configured in Layer-2 aggregate port view, the setting takes effect only on the aggregate port.
Configured on the member port in an aggregation group, the setting can take effect only after the
port leaves the aggregation group. For detailed information about link aggregation, refer to
Link
Aggregation Configuration
in the
Access Volume
.