3Com S7902E Command Reference Manual - page 1112
1-8
Field
Description
RPF Neighbor
IP address of the RPF neighbor through which
the multicast source is reachable
Matched routing protocol
If a protocol is configured, the multicast source
address of the route should be the destination
address of an entry in unicast routing table.
Route-policy
Routing policy. The multicast source address of
the route should match the routing policy.
Preference Route
preference
Order
Sequence number of the route
display multicast rpf-info
Syntax
display multicast
[
all-instance
|
vpn-instance vpn-instance-name
]
rpf-info
source-address
[
group-address
]
View
Any view
Default Level
1: Monitor level
Parameters
all-instance
: Specifies all instances.
vpn-instance vpn-instance-name
: Specifies a VPN instance. A VPN instance name is a case sensitive
string of up to 31 characters and must not contain any space..
source-address
: Multicast source address.
group-address
: Multicast group address, in the range of 224.0.1.0 to 239.255.255.255.
Description
Use the
display multicast rpf-info
command to view the RPF information of a multicast source.
Note that if neither
all-instance
nor
vpn-instance
is specified, this command displays the information
on the public instance.
Related commands:
display multicast routing-table
,
display multicast forwarding-table
.
Examples
# View all the RPF information of multicast source 192.168.1.55 in the public network.
RPF information about source 192.168.1.55:
VPN instance: public net
RPF interface: Vlan-interface1, RPF neighbor: 10.1.1.1
Referenced route/mask: 192.168.1.0/24
Referenced route type: igp