3Com S7902E Command Reference Manual - page 1829
1-13
interface-number
represents the port number, and & means that you can provide up to 10 port
indexes/port index lists for this argument. The start port number must be smaller than the end number
and the two ports must be of the same type.
Description
Use the
dot1x
port-method
command to set the access control method for specified or all ports.
Use the
undo dot1x
port-method
command to restore the default.
The default access control method is
macbased
.
Related commands:
display dot1x
.
Examples
# Set the access control method to
portbased
for port GigabitEthernet 2/0/1.
[Sysname] dot1x port-method portbased interface GigabitEthernet 2/0/1
Or
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] dot1x port-method portbased
dot1x quiet-period
Syntax
dot1x
quiet-period
undo dot1x quiet-period
View
System view
Default Level
2: System level
Parameters
None
Description
Use the
dot1x
quiet-period
command to enable the quiet timer function.
Use the
undo dot1x
quiet-period
command to disable the function.
By default, the function is disabled.
After a supplicant fails the authentication, the authenticator refuses further authentication requests from
the supplicant in the period dictated by the quiet timer.
Related commands:
display dot1x
,
dot1x timer
.
Examples
# Enable the quiet timer.