3Com S7902E Command Reference Manual - page 1826
1-10
undo dot1x
max-user
View
System view, Ethernet interface view
Default Level
2: System level
Parameters
user-number
: Maximum number of users to be supported simultaneously, in the range 1 to 1024.
interface interface-list
: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The
interface-list
argument is in the format of
interface-list
= {
interface-type
interface-number
[
to
interface-type
interface-number
] } & , where
interface-type
represents the port type,
interface-number
represents the port number, and & means that you can provide up to 10 port
indexes/port index lists for this argument. The start port number must be smaller than the end number
and the two ports must be of the same type.
Description
Use the
dot1x
max-user
command to set the maximum number of users to be supported
simultaneously for specified or all ports.
Use the
undo dot1x
max-user
command to restore the default.
With no interface specified, the command sets the threshold for all ports.
Related commands:
display dot1x
.
Examples
# Set the maximum number of users for port GigabitEthernet 2/0/1 to support simultaneously as 32.
[Sysname] dot1x max-user 32 interface GigabitEthernet 2/0/1
Or
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] dot1x max-user 32
dot1x multicast-trigger
Syntax
dot1x multicast-trigger
undo dot1x multicast-trigger
View
Interface view
Default Level
2: System level