3Com S7902E Command Reference Manual - page 1860
1-14
Description
Use the
portal auth-network
command to configure a portal authentication subnet.
Use the
undo portal auth-network
command to remove a specified portal authentication subnet or
all portal authentication subnets.
Note that this command is only applicable for Layer 3 authentication. The portal authentication subnet
for direct authentication is any source IP address, and the portal authentication subnet for re-DHCP
authentication is the one determined by the private IP address of the interface.
By default, the portal authentication subnet is 0.0.0.0/0, meaning that users in all subnets are to be
authenticated.
Examples
# Configure a portal authentication subnet of 10.10.10.0/24.
[Sysname] interface Vlan-interface 1
[Sysname- Vlan-interface1] portal auth-network 10.10.10.0 24
portal delete-user
Syntax
portal delete-user
{
ip-address
|
all
|
interface
interface-type interface-number
}
View
System view
Default Level
2: System level
Parameters
ip-address
: IP address of a user.
all
: Logs out all users.
interface interface-type interface-number
: Logs out all users on the specified interface.
Description
Use the
portal delete-user
command to log out users.
Related commands:
display portal user
.
Examples
# Log out user 1.1.1.1.
[Sysname] portal delete-user 1.1.1.1