3Com S7902E Command Reference Manual - page 363
2-25
Description
Use the
port trunk pvid vlan
command to set the default VLAN ID of the ONU port configured as a
trunk port.
Use the
undo port trunk pvid
command to restore the default.
By default, the default VLAN on a Trunk port is VLAN 1.
For a Trunk port, after you execute the
undo vlan
command to remove the default VLAN of the Trunk
port, the default VLAN of the Trunk port does not change. That is to say, the Trunk port can use the
non-existing VLAN as the default VLAN.
Related commands:
port link-type
.
Examples
# Configure the default VLAN ID for the Trunk port ONU 3/0/1:1 as 100.
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] port link-type trunk
[Sysname-Onu3/0/1:1] port trunk pvid vlan 100
reboot onu
Syntax
reboot onu
View
ONU port view
Default Level
2: System level
Parameters
None
Description
Use the
reboot onu
command to restart the ONU.
Before using this command, make sure the ONU is online.
Examples
# Restart ONU 3/0/1:1.
[Sysname] interface onu 3/0/1:1
[Sysname-Onu3/0/1:1] reboot onu
reset counters uni
Syntax
reset counters uni
[
uni-number
]