3Com S7902E Command Reference Manual - page 458
1-8
Secondary port: GigabitEthernet3/0/2 Port status: BLOCKED
# Display the detailed information of all the rings in RRPP domain 2.
Domain ID : 2
Control VLAN : Major 10 Sub 11
Protected VLAN: Reference Instance 3, 5 to 7
Hello Timer : 1 sec Fail Timer : 3 sec
Ring ID : 1
Ring Level : 0
Node Mode : Master
Ring State : Complete
Enable Status : Yes Active Status: Yes
Primary port : GigabitEthernet3/0/4 Port status: UP
Secondary port: GigabitEthernet3/0/5 Port status: BLOCKED
Ring ID : 2
Ring Level : 1
Node Mode : Edge
Ring State : -
Enable Status : No Active Status: No
Common port : GigabitEthernet3/0/4 Port status: -
GigabitEthernet3/0/5 Port status: -
Edge port : GigabitEthernet3/0/3 Port status: -
Table 1-4 display rrpp verbose
command output description
Field
Description
Domain ID
RRPP domain ID
Control VLAN
Control VLANs of the RRPP domain, including major control VLAN and sub
control VLAN
Protected VLAN
List of VLANs protected by the RRPP domain. MSTIs are displayed here.
To get the VLANs corresponding to these MSTIs, use the
display stp
region-configuration
command.
Hello Timer
Hello Timer value configured in seconds
Fail Timer
Fail Timer value configured in seconds
Ring ID
RRPP ring ID
Ring Level
RRPP ring level, with 0 representing primary ring and 1 representing
subring
Node Mode
Node mode: master node, transit node, edge node and assistant edge node
Ring State
RRPP ring state. This field makes sense only when the node mode field is
master node. “Complete” appears when the ring is in health state; “Failed”
appears when the ring is in disconnect sate; and “–” appears in all the other
cases.
Enable Status
RRPP ring enable status: Yes indicates enabled and No indicates disabled