3Com S7902E Command Reference Manual - page 945
1-5
View
Any view
Default Level
1: Monitor level
Parameters
process-id
: RIPng process ID, in the range of 1 to 65535.
interface-type interface-number
: Specifies an interface.
Description
Use the
display ripng interface
command to display the interface information of the RIPng process.
If no interface is specified, information about all interfaces of the RIPng process will be displayed.
Examples
# Display the interface information of RIPng process 1.
Interface-name: Vlan-interface100
Link Local Address: FE80::20F:E2FF:FE30:C16C
Split-horizon: on Poison-reverse: off
MetricIn: 0 MetricOut: 1
Default route: off
Summary address:
3:: 64
3:: 16
Table 1-3 display ripng interface
command output description
Field
Description
Interface-name
Name of an interface running RIPng
Link Local Address
Link-local address of an interface running RIPng
Split-horizon
Indicates whether the split horizon function is enabled (on: Enabled; off:
Disabled)
Poison-reverse
Indicates whether the poison reverse function is enabled (on: Enabled;
off: Disabled)
MetricIn/MetricOut
Additional metric to incoming and outgoing routes
Default route
z
Only/Originate:
Only
means that the interface advertises only the
default route.
Originate
means that the default route and other RIPng
routes are advertised.
z
Off
indicates that no default route is advertised or the garbage-collect
time expires after the default route advertisement was disabled.
z
In garbage-collect status: With default route advertisement disabled,
the interface advertises the default route with metric 16 during the
garbage-collect time.
Summary address
The summarized IPv6 prefix and the summary IPv6 prefix on the interface