3Com S7902E Command Reference Manual - page 1830
1-14
[Sysname] dot1x quiet-period
dot1x retry
Syntax
dot1x
retry max-retry-value
undo dot1x
retry
View
System view
Default Level
2: System level
Parameters
max-retry-value
: Maximum number of attempts to send an authentication request to a supplicant, in the
range 1 to 10.
Description
Use the
dot1x
retry
command to set the maximum number of attempts to send an authentication
request to a supplicant.
Use the
undo dot1x
retry
command to restore the default.
By default, the authenticator can send an authentication request to a supplicant twice at most.
Note that after sending an authentication request to a supplicant, the authenticator may retransmit the
request if it does not receive any response at an interval specified by the username request timeout
timer or supplicant timeout timer. The number of retransmission attempts is one less than the value set
by this command.
Related commands:
display dot1x
.
Examples
# Set the maximum number of attempts to send an authentication request to a supplicant as 9.
[Sysname] dot1x retry 9
dot1x supp-proxy-check
Syntax
In system view:
dot1x
supp-proxy-check
{
logoff
|
trap
}
[
interface interface-list
]
undo dot1x
supp-proxy-check
{
logoff
|
trap
}
[
interface interface-list
]
In Ethernet interface view:
dot1x
supp-proxy-check
{
logoff
|
trap
}
undo dot1x
supp-proxy-check
{
logoff
|
trap
}