3Com S7902E Command Reference Manual - page 2190
1-17
address of the specified interface. If you want to display the source IP address in the log information,
you can configure it by using this command.
Note that:
z
The
info-center loghost source
command takes effect only after the information center is
enabled with the
info-center enable
command.
z
The IP address of the specified source interface must be configured; otherwise, although the
info-center loghost source
command can be configured successfully, the log host will not receive
any log information.
Examples
# Configure interface VLAN-interface 1 as the egress interface to output log information to the log host.
[Sysname] info-center loghost source Vlan-interface 1
info-center monitor channel
Syntax
info-center monitor channel
{
channel
-
number | channel
-
name
}
undo info-center monitor channel
View
System view
Default Level
2: System level
Parameters
channel
-
number
: Specifies a channel number, in the range 0 to 9.
channel
-
name
: Specifies a channel name, which could be a default name or a self-defined name. The
user needs to specify a channel name first before using it as a self-defined channel name. For more
information, refer to the
info-center channel name
command.
Description
Use the
info-center monitor channel
command to configure the channel to output system information
to the monitor.
Use the
undo info-center monitor channel
command to restore the default channel to output system
information to the monitor.
By default, output of system information to the monitor is enabled with a default channel name of
monitor and a default channel number of 1.
Note that the
info-center monitor channel
command takes effect only after the information center is
enabled with the
info-center enable
command.
Examples
# Set to output system information to the monitor through channel 0.