3Com S7902E Command Reference Manual - page 180
1-17
undo lldp check-change-interval
View
Ethernet interface view, port group view
Default level
2: System level
Parameters
value
: LLDP polling interval to be set, in the range 1 to 30 (in seconds).
Description
Use the
lldp check-change-interval
command to enable LLDP polling and set the polling interval.
Use the
undo lldp check-change-interval
command to restore the default.
By default, LLDP polling is disabled.
With LLDP polling enabled, LLDP detects for local configuration changes periodically. A local
configuration change triggers LLDPDU sending, through which neighboring devices can be informed of
the configuration change timely.
Examples
# Enable LLDP polling on GigabitEthernet2/0/3, setting the polling interval to 30 seconds.
[Sysname] interface gigabitethernet2/0/3
[Sysname-GigabitEthernet2/0/3] lldp check-change-interval 30
lldp compliance admin-status cdp
Syntax
lldp compliance admin-status cdp
{
disable
|
txrx
}
View
Ethernet interface view, port group view
Default Level
2: System level
Parameters
disable
: Specifies the disable mode, where CDP-compatible LLDP neither receives nor transmits CDP
packets.
txrx
: Specifies the TxRx mode, where CDP-compatible LLDP can send and receive CDP packets.
Description
Use the
lldp compliance admin-status cdp
command to configure the operation mode of
CDP-compatible LLDP on a port or port group.
By default, CDP-compatible LLDP operates in disable mode.