3Com S7902E Command Reference Manual - page 665
1-5
sflow sampling-mode
Syntax
sflow sampling-mode
{
determine
|
random
}
undo sflow sampling-mode
View
Interface view
Default Level
2: System level
Parameters
determine
: Indicates to sample a fixed number of packets.
random
: Indicates to sample packets randomly.
Description
Use the
sflow sampling-mode
command to specify the packet sampling mode.
Use the
undo
sflow sampling-mode
command to restore the default.
By default, the packet sampling mode is
random
.
Note that this command should be used after sFlow is enabled on the current port.
Currently, the
determine
mode is not supported on S7900E series Ethernet switches.
Examples
# Specify the sFlow sampling mode as
random
on GigabitEthernet 2/0/1.
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] sflow enable inbound
[Sysname-GigabitEthernet2/0/1] sflow sampling-mode random
sflow sampling-rate
Syntax
sflow sampling-rate rate
undo sflow sampling-rate
View
Interface view