3Com S7902E Command Reference Manual - page 2107
1-2
Table 1-1
display snmp-agent community command output description
Field
Description
Community name
Community name
z
If a community name is created by using the
snmp-agent
community
command, the community name will be displayed.
z
If a community name is created by using the snmp-agent usm-user
{ v1 | v2c } command, the user name will be displayed.
Group name
SNMP group name
z
If a community name is created by using the
snmp-agent
community
command, the group name and the community name
are the same, which means the community name will be displayed.
z
If a community name is created by using the snmp-agent usm-user
{ v1 | v2c } command, the name of the group to which the user
belongs will be displayed.
Acl
The number of the ACL in use
After an ACL is configured, only the Network Management Station
(NMS) with the IP address that matches the ACL rule can access the
device.
Storage-type
Storage type, which could be:
z
volatile
: Information will be lost if the system is rebooted
z
nonVolatile
: Information will not be lost if the system is rebooted
z
permanent
: Information will not be lost if the system is rebooted.
Modification is permitted, but deletion is forbidden
z
readOnly
: Information will not be lost if the system is rebooted.
Read only, that is, no modification, no deletion
z
other
: Other storage types
display snmp-agent group
Syntax
display snmp-agent group
[
group-name
]
View
Any view
Default Level
1: Monitor level
Parameters
group-name
: Specifies the SNMP group name, a string of 1 to 32 characters, case sensitive.
Description
Use the
display snmp-agent group
command to display information for the SNMP agent group,
including group name, security model, MIB view, storage type, and so on. Absence of the
group-name
parameter indicates that information for all groups will be displayed.
Examples
# Display the information of all SNMP agent groups.